5 Fuel Saving Tips to Get Maximum Bike Efficiency

As the warmer weather starts to roll in, it’s time to dust off the ol’ bicycle and get back on the road! Biking is not only a great way to get some exercise, but it’s also a great way to save money on fuel. Here are 5 fuel saving tips to get maximum bike efficiency so you can save money and help the environment!

It all starts with proper maintenance

We all know that maintaining our bikes properly is essential to keeping them running smoothly and efficiently. But did you know that there are some specific things you can do to maximize your bike’s fuel efficiency? Here are a few tips to get the most out of your bike:

1. Check your tire pressure regularly – Underinflated tires can reduce your fuel economy by up to 3%.
2. Keep your chain well-lubricated – A dry or rusty chain can increase friction and drag, costing you precious fuel.
3. Keep your bike clean – A dirty bike will have to work harder to overcome air resistance, using up more fuel in the process.
4. Avoid excessive idling – If you’re going to be stopped for more than 30 seconds, it’s best to turn off your engine. Otherwise, you’re just wasting gas.
5. Use the correct grade of oil – Be sure to use the grade of oil recommended by your bike’s manufacturer. Using a heavier weight oil can actually decrease fuel economy.

Keep a check on driving practices

Driving habits can have a big impact on fuel efficiency. Here are some tips to help you get the most out of your bike:

– avoid hard acceleration and braking; both can waste fuel

– try to maintain a steady speed; fluctuating speeds can use up more gas

– when climbing hills, shift to a lower gear instead of revving the engine

– Coasting downhill doesn’t save fuel, so don’t do it!

– always maintain economy speed of bike

By following these tips, you can help your bike run more efficiently and save money on gas.

Don’t rev your engine too hard

If you’re trying to get the most out of your bike in terms of fuel efficiency, you’ll want to avoid revving the engine too hard. This puts unnecessary strain on the engine and can actually use up more fuel in the long run. Instead, try to keep a steady throttle and take advantage of your bike’s torque. This will help you get better mileage and keep your engine running smoothly.

Routinely change the engine oil

1. Routinely change the engine oil

As with any car, motorcycle or scooter, it is important to routinely change the engine oil according to the manufacturer’s recommendations. This will help ensure that your bike’s engine is running smoothly and efficiently.

Also Read: Best Scooters in India 2020 for Performance and Mileage

2. Use the correct grade and type of oil

Be sure to use the correct grade and type of oil for your bike as specified in the owner’s manual. Using a higher grade oil than necessary can actually lead to increased fuel consumption.

3. Check tire pressure regularly

Under-inflated tires can adversely affect fuel economy, so be sure to check your bike’s tire pressure regularly and inflate to the recommended level if needed.

4. Minimize idling time

Whenever possible, try to minimize the amount of time you spend idling, as this can waste fuel unnecessarily. If you know you’ll be stopped for more than 30 seconds or so, it’s often better to turn off your engine until you’re ready to move again.

Also Read: 5 Best Scooters In India For Those Busy Roads!

By following these simple tips, you can help improve your bike’s fuel efficiency and save money at the pump!

Turn off your engine on traffic signals

If you’re stopped at a red light or in stop-and-go traffic, it’s more efficient to turn off your engine and coast until it’s time to go again. That way, you’re not wasting fuel by idling. Plus, it’s better for the environment.

If you are looking to buy a two wheeler then Muthoot Capital is there to help with best two wheeler loan options.